Publicly accessible general discussion
  • User avatar
  • User avatar
  • User avatar
By N_Jay
#317068
I have a line on a 914 transmission, and a place to store it, but might need a local set if hands to get it from the seller to my brother's place.

Kennett Square to Garrett Valley.
By fpena944
#317294
N_Jay wrote: Thu Aug 21, 2025 11:54 amOh well.
Did you end up purchasing it?

My wife's brother lives outside of York but he's not into cars and doesn't drive any more than he has to or I would have volunteered his services.
By N_Jay
#317295
fpena944 wrote: Thu Aug 21, 2025 2:12 pm
N_Jay wrote: Thu Aug 21, 2025 11:54 amOh well.
Did you end up purchasing it?

My wife's brother lives outside of York but he's not into cars and doesn't drive any more than he has to or I would have volunteered his services.
I expect to, as it is a bit less than what the core charge is at most rebuilders.
Mine works, but is not great.
I have one spare but don't know the condition.
I figure with another it might encourage me to crack one open and see what I can screw up on my own.

I have to wait for my brother to get back from Seattle.
His back is not great so he was worried about getting out of his car. (~75LB)
By N_Jay
#317305
i am not a traitor wrote: Thu Aug 21, 2025 4:07 pm I'm going right past Kennet Square next weekend on my way to Broadkill Beach. However, I'll have the truck loaded up and wouldn't have any room.
No problem, I think I have my brother shamed into it. :drink:
help with digi dash

finally had to get round to proving the mileage of[…]

I just installed the Aero Strut Bar this evening. […]

what is a good, all original wiring at the rear[…]

Perfect used parts question

Note final statement in original post. SEARCH TE[…]