Open Road

New batch of parts are in.

Distributor plates after a thin coat of SEM trim paint. For mine I'm going to powdercoat them to match the top cam belt covers.

I’m converting to cop just for those plates!

Crumpler wrote: ↑Sun Mar 23, 2025 10:57 am I’m converting to cop just for those plates!

wait until you see the anodized rotor hats~!

Are those Cam Seal Retainers anodized?

Seal retainers will be available in black anodized and as machined in the pic above so that people can paint/ceramic coat/powdercoat custom colors if they like.

Black anodized on the left and as machined on the right. I’ll be going with black anodized for mine.

What else is in the product pipeline boss?
Curious.

I want an oil filler neck.
Want big -AN hookups on that filler neck.
I don’t care anymore if fill port is stock cap size.
:)

lots of stuff in the pipeline. parts and custom tools as well. the goal is to release 32 parts this year in small batches of 4-5 at a time & sold thru Roger. The rotor hats will make some nice choices out there for the 928. Stock is pictured above and will allow you to mount a 355mm front rotor on an S4 or later front spindle so for those with 86.5 track cars or earlier track cars with 86.5 or later front spindles you could put some massive brakes on. I also have a different rotor hat available for those that decide to go with the "negative spacer trick" and go with 944 hubs to provide more wheel and offset choices.

How long until these parts hit your storefront?

I am in for a set of the anodized cam seal retainers.

Seth K. Pyle

cam seal retainers will be sold thru Roger. I'm hoping to get them to him this week.

Thanks!

They are finally up on Roger's site

Anodized:

https://928srus.com/products/billet-cam ... k-anodized

Plain:

https://928srus.com/products/billet-cam ... ned-finish