By sh944 - Mon Aug 30, 2021 5:16 pm
- Mon Aug 30, 2021 5:16 pm
#101139
At the top of the windshield of the Boxster Spyder, there are two end plugs that have a tendency to disappear. Here is a replacement for both driver and passenger sides.
I have no idea if this fits any other models.
I'd give credit to the guy that provided the original work on this part, if I knew who it was. I have since modified it and changed the orientation so that it prints better. Plain ol' black PLA works fine for this, change up the resolution if you want or just do what I did and hit it with some 300 grit sandpaper to get the factory rubber look. I'd also suggest a touch of silicon where it slides into the seal to keep it in place.
I have no idea if this fits any other models.
I'd give credit to the guy that provided the original work on this part, if I knew who it was. I have since modified it and changed the orientation so that it prints better. Plain ol' black PLA works fine for this, change up the resolution if you want or just do what I did and hit it with some 300 grit sandpaper to get the factory rubber look. I'd also suggest a touch of silicon where it slides into the seal to keep it in place.
You do not have the required permissions to view the files attached to this post.
Following the path of least resistance to the lowest common denominator since 1961... My pronouns are “curmudgeon”, “geezer” and “I don’t give a shit what yours are”. "Designed by clowns who are in turn supervised by monkeys" doesn't apply to just Boeing
- By David993S
- By worf
- By Bertrand Daoust
- By maddog2020