Share your 3D printer files for reproduction parts or models
  • User avatar
By sh944
#101139
Porsche Spyder roof seal cap ver2.3mf
At the top of the windshield of the Boxster Spyder, there are two end plugs that have a tendency to disappear. Here is a replacement for both driver and passenger sides.

I have no idea if this fits any other models.

I'd give credit to the guy that provided the original work on this part, if I knew who it was. I have since modified it and changed the orientation so that it prints better. Plain ol' black PLA works fine for this, change up the resolution if you want or just do what I did and hit it with some 300 grit sandpaper to get the factory rubber look. I'd also suggest a touch of silicon where it slides into the seal to keep it in place.
You do not have the required permissions to view the files attached to this post.
leaky coolant overflow tanks

Found it ......... LAND ROVER 200/300 TDI/ V8 ALUM[…]

Toyota 4Runner

I made a brief post along time ago but this belo[…]

The 928 Photo Thread

Yes. The passenger side started to make a bit of n[…]

Maybe give the latest CRV a look? The newer […]